3 Setting Up a Single-axis Servo System
3-7-3
Checking Program Operation
You will change the operating mode of the CPU Unit to RUN mode and then use monitoring, control
BOOL variables (set/reset), and use the MC Monitor Table in the Ladder Editor to check the operation
of the program that you created. Control (set/reset) the status of the inputs to control the motion control
instructions, and use the MC Monitor Table to check the results of their execution.
1
Double-click Section0 under Programming − POUs − Programs − Program0 in the Multiview
Explorer.
The ladder program is displayed in the monitored state in the Edit Pane.
3-36
NJ-series Startup Guide for Motion Control (W514)