Troubleshooting - Santak K Series User Manual

* Normal Mode
* The initial value of the new battery
The Caution!
This product is a Class C2 UPS for use in residential areas where
installation restrictions or additional facilities may be required to
suppress radio frequency harassment.
High altitude area loading=
Altitude
Derating factor
Note: If the UPS is used at an altitude of 1000m or more, must be used
to reduce the rated output, derating coefficient see the table above.
Trouble shooting
If the UPS is running abnormally, please refer to the following table
to confirm the phenomenon, to be processed. If you can't properly
handle, please contact the distributor.
UPS input plug is plugged into mains plug
Seat and the electricity is normal, the
power switch has been pressed Under,
but the green light flashes, the buzzer
beep.
Battery mode power failure:
In the event of a power failure, the UPS
automatically shuts down automatically.
Green light flash, buzzer beep per 2
seconds .
Green light off, buzzer beep
continuously .
Rated power * Derating factor
1000m
100%
Problem
1500m
95%
Please contact
replacement.
Is the battery damaged?
When the electricity is normal,
charge the battery for more than 6
hours, if the fault is reproduced, then
The battery may be damaged, or the
charging circuit is faulty. Please
contact the distributor.
Please contact the distributor.
UPS output short circuit, or other
internal fault. Please contact the
distributor.
1
2000m
91%
Remedy
the distributor
for