Table of Contents
Advertisement
SUN2000-(33KTL, 36KTL, 40KTL)-US
User Manual
If the DC input power cable is reversely connected, do not operate the DC switches and
positive and negative connectors immediately. Otherwise, the SUN2000 will be damaged. The
caused equipment damage is beyond the warranty scope. Wait until the solar irradiance
declines at night and the PV string current reduces to below 0.5 A. Then, turn off the two DC
switches, remove the positive and negative connectors, and correct the polarity of the DC
input power cable.
----End
Follow-up Procedure
Before removing the positive and negative connectors, ensure that the two DC switches are
OFF.
To remove the positive and negative connectors from the SUN2000, insert an open-end
wrench into the notch and press the wrench with an appropriate force.
Figure 5-35 Removing a DC input connector (Amphenol Helios H4)
Figure 5-36 Removing a DC input connector (MC4)
If you replace the SUN2000 that uses the Amphenol Helios H4 DC terminal with the
SUN2000 that uses the MC4 DC terminal, you are advised to replace the DC input connector
on the cable with the supplied MC4 DC input connector.
Issue 07 (2019-06-20)
Copyright © Huawei Technologies Co., Ltd.
5 Connecting Cables
70
Advertisement
Table of Contents
