Table of Contents
Advertisement
SUN2000-(33KTL, 36KTL, 40KTL)-US
User Manual
Follow-up Procedure
Before connecting cables, prepare a Φ2 in. tube and perform the following operations. Failing
to do so may cause reworking.
1.
2.
3.
4.
5.
6.
7.
8.
Figure 4-28 Installing a front cover
Issue 07 (2019-06-20)
Secure the pipe fitting to the enclosure using the nut delivered with the pipe.
Route the ground cable that needs to connect to the ground point on the PV side and the
DC input power cable through the tube conduit and then fittings.
Connect the ground cable to the ground point on the PV side (see
Grounding).
Connect the DC input power cable by following the instructions in
Input Power
Cables.
Connect the conduit and fitting of the pipe.
Check that the cables are connected correctly and securely. Then take appropriate
measures to ensure that the pipe conduit and fitting are secured reliably, and seal the
cable hole.
Clear foreign matter from the protection shroud.
Install the front cover of the protection shroud.
Copyright © Huawei Technologies Co., Ltd.
4 System Installation
5.2.2 PV Side
5.5 Connecting DC
39
Advertisement
Table of Contents
