Maintenance Of The Cutter - Titan VS-32-L Operating And Maintenance Instructions Manual

9.7. Maintenance of the cutter

The cutting edge of the cutter must be checked regularly in the same way as it is done
with the clamping or stationary cutter edges. If that edge is notch or broken, it must be
replaced.
Cutter
Dismounting and mounting operations
The following tools are required for dismounting and mounting operations:
Spring hooks, hexagon socket screw keys SW 6.
To dismount the cuter relieve the pressure springs (116) by means of spring
hooks (fig. 17).
The sealing unit can now be tilted open and the cutter guidance can be removed
from the clamp guide by the loosening of the cheese-head screw (fig. 18).
Mounting is performed in the reverse order.
Fig. 17: Sealing unit tilted open.
VS-32-L
Cutting edge
Attention!
Broken cutter edges may cause faults in strap feed and return
motions. The beginning of the strap is bent!
116
B 13 GB 04/13
Fig. 18: Dismounting cutter guide.
580 /
581
44