Britax Safe-n-Sound BS7300E-i20133 Series Instructions For Installation & Use page 45

E. Remove the cover by unclipping any press studs
from the moulding and from the cover middle
panel
F. Feed crotch buckle through crotch strap slot in the
cover and feed the shoulder harness behind the
centre flap.
IMPORTANT:
Do not remove the impact foam attached to the side wings. Ensure the shoulder harness is routed over the
bar if harness straps are removed.
88
Instructions for Installation & Use
Unclip
press
stud from
moulding
Unclip
the press
studs
Crotch
slot
TO REPLACE COVER:
A. Feed the harness tongues and shoulder straps through
the side slots in the cover.
B. Stretch the cover over the top of the restraint first, then
the sides, then stretch the cover around the rim of the
restraint. Attach the elastic loops at the top of the cover
located at the back of the restraint and the elastic loops
at the bottom of the restraint located under the front of
the restraint. Re-attach and press studs to the moulding.
Feed the crotch buckle through slot in cover.
C. Pull the adjuster strap through the cover. Ensure none of
the harness straps are twisted.
To replace headrest cover for adjustable headrest
without side wings:
Fit headrest cover over headrest without side wings, feed
through shoulder harness straps and re-attach the press
studs. Hook elastic loop to the headrest without side wings
hardware.
Hook elastic loop at the back of
the restraint
Press
Hook elastic loop
Studs
headrest without
side wings hardware
89
Instructions for Installation & Use