Britax Safe-n-Sound BS7300E-i20133 Series Instructions For Installation & Use page 27

E. Press the blue button on left side (facing seat) and
gently push stabilising bar back and then down into the
recessed area.
F. Re-attach the seat pad at the end of the seat.
Store instruction manual in pocket provided and tuck
pocket under trim cover.
DISCONNECT TOP TETHER AND
ISOFLEX CONNECTORS
To store the ISOFLEX connectors on the inside of
the seat wings.
A. Press the ISOFLEX strap adjuster button to
release tension on the straps.
B. Press each of the red release buttons on the
ISOFLEX connectors and remove them from the
vehicle ISOFIX low anchorages.
C. Fully lengthen the ISOFLEX strap and engage
each ISOFLEX connector onto its storage pin.
Remove slack but do not tighten. The storage pin
may be damaged if the strap is tightened.
52
Instructions for Installation & Use
Rotate forward 2
Then push
inwards
1
3
Button under trim
D. Remove the excess tether strap from pocket and fully
press top tether adjuster button (1) while pulling top
tether strap (2) to slacken as shown. In some vehicles
loosening of the top tether strap may be difficult. If so,
try pushing the restraint against the vehicle seat back
or slightly lifting the restraint to release the tension.
E. Disengage the attachment clip from upper anchorage
fitting.
Store loose strap in the storage pocket provided on
the cover.
F. Disengage the attachment clip from upper anchorage
fitting. The child restraint is now disconnected.
Store loose strap in the storage pocket provided on
the cover.
G. To store the stabilising bar, lift the front flap at the end
of the seat, this uncovers the stabilising bar storage
recess.
H. Press the blue button on left side (facing seat) and
gently push stabilising bar back and then down into the
recessed area.
I. Re-attach the seat pad at the end of the seat.
Fully press Adjuster Button (1) while
pulling Upper Anchorage Strap (2) to
lengthen.
1
2
Press stud
attachment
Stabilising
bar
Front flap
Rotate forward
2
Then push
inwards
1
3
Button under trim
53
Instructions for Installation & Use