Britax Safe-n-Sound BS7300E-i20133 Series Instructions For Installation & Use page 14

ISOFLEX Connectors are
35
stored on each side of the seat
34
ISOFLEX CONNECTORS (IF SUPPLIED)
29. ISOFLEX Strap Adjuster Button
30. ISOFLEX Connector Release Button
31. ISOFLEX Connector Indicator
32. ISOFLEX Connector
33. ISOFLEX Adjustment Strap
34. Tension Indicator (Green when activated )
35. ISOFLEX Connectors (stored on each side of the seat) (if supplied)
26
Instructions for Installation & Use
29
30
33
31
32
IS THERE ENOUGH ROOM
To ensure that the space is sufficient, the
purchaser should check the measurements
between the vehicle's rear and front seats in
which the child restraint is intended to be used.
DO NOT USE RESTRAINT IN REARWARD FACING
MODE WITHOUT THE STABILISING BAR FULLY
EXTENDED.
Do not use the restraint without the top tether strap
correctly attached.
DO NOT USE A REAR FACING CHILD RESTRAINT
WHERE AN AIRBAG IS FITTED IN FRONT OF THE
SEATING POSITION.
Do not use on any vehicle seat which faces sideways or
rearwards.
CHILD RESTRAINT UPPER ANCHORAGE FITTING
To use this child restraint, the car will need a child restraint upper anchorage fitting in the seating position
that you intend to use. Refer to the car owner's handbook.
If no upper anchorage fitting is provided then you will need to install an upper anchorage fitting. Refer to
pages 95 to 98.
The upper anchorage fitting is required for attaching the top tether in both rear facing mode and forward
facing mode covered later in the these instructions.
375mm
520mm
Seat width 450mm
Do not allow the front seat to alter
the installed angle of the restraint. It
is permissible to allow the restraint to
touch the front vehicle seat.
27
Instructions for Installation & Use