Britax Safe-n-Sound BS7300E-i20133 Series Instructions For Installation & Use page 10

• Fit the restraint firmly to the car seat.
• Fit the harness firmly to the child.
• A loose restraint or harness is dangerous.
• Supervision of children is needed because they may be able to undo the buckles and adjusters.
• Use the restraint exactly as shown in the instructions.
• DO NOT LEAVE CHILDREN UNATTENDED IN THE CAR.
• Do not alter or modify this restraint.
• Repairs must only be done by the manufacturer or agent.
• Do not allow the restraint to come into contact with polishes, oils, bleach and other chemicals.
• Destroy the restraint if it has been in a severe crash, even if no damage is visible. See page 101.
• DO NOT USE THIS RESTRAINT WITHOUT THE COVER.
• Always secure the loose end of the top tether strap. Do not use the child restraint where this top tether
strap may fall into a split in the seat back or off the side of the seat.
• ALWAYS ATTACH TOP TETHER HOOK AND REMOVE SLACK.
• To ensure infant's back is evenly supported, do not put more than one nappy on the baby and make
sure the nappy is not thickly folded at the back.
• DO NOT USE A REAR-FACING CHILD RESTRAINT WHERE AN AIRBAG IS FITTED IN FRONT OF
THE SEATING POSITION.
• Do not harness an infant wrapped in a blanket or swaddled. Any blanket or wrap must only be placed
over the harness and infant.
18
Instructions for Installation & Use
IMPORTANT :
NON ISOFIX COMPATIBLE: FOR INSTALLATION WITH SEATBELT ONLY
TO BE USED WITH LAP-SASH OR LAP ONLY SEATBELTS IN THE BACK OF MOST CARS WITH
FORWARD FACING SEATS.
• Without ISOFIX compatible connectors; This child restraint is not approved for use with any connectors
that connect to the car's ISOFIX low anchorages.
ISOFIX COMPATIBLE: FOR INSTALLATION WITH ISOFLEX CONNECTORS
• TO BE USED WITH A LAP-SASH OR LAP-ONLY SEATBELT OR ISOFIX LOW ANCHORAGES IN
THE BACK OF MOST CARS WITH FORWARD FACING SEATS.
• Do not attach the lower attachment connectors of two separate child restraints to the same
ISOFIX low anchorages in your car.
• Always attach the top tether strap to the child restraint upper anchorage in your car before each
journey.
• Child restraint lower attachment connectors and the ISOFIX low anchorages in your car are designed to
withstand only those loads imposed by a correctly fitted child restraint.
GENERAL
• Regularly check the restraint components, straps and other fitments for correct function and condition. If
faulty, cease using and seek repair by Britax.
• IF AN AIRBAG IS FITTED IN THE SEATING POSITION WHERE THE CHILD RESTRAINT IS TO BE
FITTED, FOLLOW THE VEHICLE MANUFACTURERS WARNINGS AND INSTRUCTIONS.
• Protect all webbing from abrasion and cutting by sharp corners and edges.
• The restraint should not be purchased or sold as a second hand item. It is recommended not to use
child restraints older than 10 years as the protection in an accident may be reduced.
• THIS RESTRAINT IS NOT SUITABLE FOR USE WHERE THE TOP TETHER STRAP MAY FALL INTO
A SPLIT IN THE SEAT BACK OR OFF THE SIDE OF THE SEAT.
• Seatbelt extenders are not recommended to be used if the seatbelt is not long enough to secure the
child restraint. If seatbelts are too short then seek advice from a child restraint fitter and consider their
recommendations before using a seatbelt extender. If you use a seatbelt extender then ensure that the
seatbelt buckle does not enter the rearward or forward facing belt paths.
• THIS RESTRAINT MUST BE ATTACHED TO A CHILD RESTRAINT UPPER ANCHORAGE POINT
IN THE CAR. REFER TO CAR OWNER'S HANDBOOK FOR LOCATION OF UPPER ANCHORAGE
POINTS. REFER TO A CHILD RESTRAINT FITTING STATION IF NO UPPER ANCHORAGE POINTS
ARE IN THE MOTOR CAR. Refer to pages 95 to 98.
19
Instructions for Installation & Use