Britax Safe-n-Sound BS7300E-i20133 Series Instructions For Installation & Use page 41

THIS RESTRAINT IS SUITABLE FOR USE ON AN AIRCRAFT WHEN
INSTALLED AS DIRECTED.
HOW TO INSTALL USING AIRCRAFT LAP BELT
The child restraint must be used in accordance with the aircraft procedures, and any directions from the
aircraft operator, pilot or crew.
Some child restraints may not fit in smaller aircraft and can not be used with aircraft seatbelts that contain
airbags unless they can be disabled.
Inform the aircraft operator that a child restraint is intended to be used on the aircraft when booking the
flight as the child restraint may not be suitable for use in that operator's aircraft.
Follow the instructions of the flight crew or pilot.
For use of the child restraint in cars in countries other than Australia and New Zealand as follows:
(A) The child restraint may not be acceptable for use in cars.
(B) The user may need to consult the country's local authorities, car hire companies, car insurance
companies, etc. for advice.
TO FIT THE CHILD RESTRAINT TO THE AIRCRAFT SEAT IN FORWARD
FACING:
A. Set the recline position to fully upright. Position the restraint in forward-facing mode and align centrally
with the chosen seating position. We recommend to fit the restraint nearest the window or in a middle
seat if in centre seating area, so it will not interfere with an adult exiting the row of seats. If possible, lift
the armrests out of the way to improve access to installing the aircraft lap belt. However airline staff will
direct you to the desired seat position.
80
Instructions for Installation & Use
B. The top tether is not required to be used to fit the child
restraint in an aircraft. Shorten the top tether strap and
store in its storage pocket. Attach the tether clip to the
elastic loop provided on the restraint as shown.
IMPORTANT:
When the tether hook is stored on the loop always
remember to attach the upper tether strap when
reinstalling in the car.
C. Fully lengthen seatbelt. Thread the seatbelt into
AIRCRAFT BELT PATH
seatbelt path marker
(lower green marker) as shown, ensuring that the
seatbelt is behind the harness straps and below the
hook as shown, on each side. Engage seatbelt buckle
and tongue.
D. Push down on the restraint and remove all slack from
the seatbelt.
E. Place child in the seat, fit the harness, engage buckle
and remove the slack in the harness.
Ensure seatbelt is
below the hooks on
both sides
Aircraft seatbelt
AIRCRAFT BELT PATH
;
marked in green.
81
Instructions for Installation & Use