Britax Safe-n-Sound BS7300E-i20133 Series Instructions For Installation & Use page 31

INSTALLING INTO VEHICLE FORWARD FACING -WITH SEATBELT
A. Position the restraint in forward facing mode
and align restraint centrally with the chosen
seating position.
Some vehicle seat fabrics (particularly
velours) may be damaged by a child restraint
used continuously. We recommend the use of
a long Messy Mat™or thick towel to keep the
vehicle seat in good condition.
B. Fully lengthen seatbelt. Insert seatbelt tongue
through the forward facing seatbelt path
(yellow), ensuring that the seatbelt is behind
the harness straps (as shown). Ensure the lap
part of the seatbelt is below the hooks.
C. Engage the vehicle seatbelt buckle and
tongue. Remove all slack from the lap part of
the seatbelt by pulling sash belt.
60
Instructions for Installation & Use
Fit firmly
to car
seat
Under Hooks
D. Grasp the sash belt edge between thumb and
fingers in each hand. Slide the belt up into the
lock-off slot to the top of the slot. If the sash belt is
not slack it may not enter the lock-off slot.
E. Pull the sash belt through the lock-off (if supplied)
to fully tighten the seatbelt. Pull the sash belt
firmly. Recheck the lap belt remains tight without
slack. Recheck the sash belt remains tight by
pulling any slack through the lock-off. Feed any
slack back into the retractor. The child restraint
should now be firmly fitted to the vehicle seat.
F. Always check all slack is removed from the lap
belt by pulling the sash belt through the lock-off
G. Push down on seat, whilst pulling the sash belt
firmly to tighten the seatbelt. This will make the
lap belt very tight across the restraint. Allow the
excess sash belt to feed back into retractor.
Always remove slack from seatbelt.
A loose seatbelt is dangerous.
Slacken the sash belt and feed into
the lock-off
Ensure
lap part of
seatbelt is
below the
hooks
Push
down
Pull the sash belt
through the lock-
off (if supplied)
to fully tighten
the seatbelt
61
Instructions for Installation & Use