Britax Safe-n-Sound BS7300E-i20133 Series Instructions For Installation & Use page 19

ANGULAR ADJUSTMENT OF RESTRAINT
Some vehicle seats have more rearward slope than others. If the angle of the seat causes the baby to
be too upright for comfort, the angle may be altered by placing a firm packing between the seat and the
underside of the base. Packing can be a firmly rolled up towel.
If the car's seat is flat then some packing may be required at the front edge of the base to achieve the
recline angle.
Do not remove all of the rearward slope by over packing. Always leave a rearward slope angle of
approximately 10 to 15 degrees as shown
10° to 15°
36
Instructions for Installation & Use
The stabilising
bar does not need
to contact the
back of the car's
seat, provided the
seatbelt is tight. If
desired this gap
may be packed.
INSTALLING THE RESTRAINT INTO THE CAR
(USING ISOFLEX CONNECTORS IF SUPPLIED TO THE CHILD RESTRAINT)
To prevent damage to vehicle seat it may be necessary to remove or open a trim covering the ISOFIX low
anchorages.
A. Locate the ISOFIX Low
Anchorages in the vehicle
rear seat. If you cannot locate
the ISOFIX bars, check your
vehicle owners manual.
The location may be
identified by one of the
following symbols.
ISOFIX low anchors in the
vehicle rear seat
B. With the restraint upright, remove both ISOFLEX
connectors from storage on the sides of the restraint by
pressing the red button on the connector.
C. Setup the seat for rear-facing mode by fully reclining the
restraint and pulling out the stabilising bar, See page 28
and 29.
37
Instructions for Installation & Use