Britax Safe-n-Sound BS7300E-i20133 Series Instructions For Installation & Use page 33

Attachment Clip
Car's Upper
Anchorage Fitting
Top tether strap
Pull to remove
slack, then store
the strap in the
Pull to tighten belt pocket
Seatbelt
'Lock-off'
FORWARD FACING
BELT PATH;
marked in yellow.
Hook
FORWARD-FACING
BELT PATH;
marked in
yellow.
IMPORTANT:
Always secure the loose end of the top tether strap to
prevent it hanging out of the car or being accessible by the child.
THIS RESTRAINT IS NOT SUITABLE FOR USE WHERE THE TOP TETHER
STRAP MAY FALL INTO A SPLIT IN THE SEAT BACK OR OFF THE SIDE
OF THE SEAT.
64
Instructions for Installation & Use
INSTALLING THE RESTRAINT INTO THE CAR
(USING ISOFLEX CONNECTORS IF SUPPLIED WITH THE CHILD RESTRAINT)
To prevent damage to vehicle seat it may be necessary to remove or open a trim covering the ISOFIX low
anchorages.
Top Tether
Adjustment Strap
A. Locate the ISOFIX Low
Top tether storage Anchorages in the vehicle
rear seat. If you cannot locate
pocket
the ISOFIX bars, check your
vehicle owners manual.
B. With the restraint upright, remove both ISOFLEX
connectors from storage on the upper sides of the restraint
by pressing the red button on the connector and removing
from the storage location.
C. Recline instructions are shown on page 59.
The location may be
identified by one of the
following symbols.
ISOFIX low anchors in the
vehicle rear seat
Push release
button
Remove
Instructions for Installation & Use
65