Britax Safe-n-Sound BS7300E-i20133 Series Instructions For Installation & Use page 20

E. Press and hold the ISOFLEX adjuster release
button and pull the connector strap to fully
lengthen. Repeat for the other connector.
F. Place the restraint in the desired location on
the vehicle seat between the two ISOFIX low
anchorages with the child seat against the vehicle
seat back as shown.
G. The stabilising bar need not be in contact with
the vehicle seat back but must be extended and
latched. Engage the ISOFLEX connectors into
each ISOFIX low anchorage. A click may be felt
and a green indicator will show on the top of
the ISOFLEX connector when it has engaged.
Pull each strap to ensure both lower anchorage
connectors are engaged. Pull the adjusting strap
to remove most of the slack on each side but do
not tighten.
38
Instructions for Installation & Use
Pull to check
connection
Remove slack
H. Push downwards on the seat to compress the seat
into the vehicle. Whilst pushing into the seat, pull
on adjuster strap to remove all slack and tighten the
ISOFLEX strap. Repeat for the adjuster strap on the
other side of the restraint. The two tension indicators
will show green indicating minimum tension has been
applied.
Always remove slack from ISOFLEX Straps.
A loose installation is dangerous.
IMPORTANT:
Do not attach the lower attachment connectors of
two separate child restraints to the same ISOFIX low
anchorages in your car.
Always attach the top tether strap to the child
restraint upper anchorage in your car.
Child restraint lower attachment connectors and the
ISOFIX low anchorages in your car are designed to
withstand only those loads imposed by a correctly fitted
child restraint.
Pull ISOFLEX adjuster
Tension
strap to remove slack and
indicator
activate indicator
39
Instructions for Installation & Use