Britax Safe-n-Sound BS7300E-i20133 Series Instructions For Installation & Use page 37

ADJUSTING HASSLE FREE HARNESS™
HEADREST
A. Loosen the harness straps before adjusting the headrest.
B. To adjust the headrest, pull on the latch on the back of
the restraint and pull up or down to position the top of the
shoulder strap slot above the child's shoulders. Release
the latch to lock the headrest in position. Pull headrest
upwards to check it is locked in position.
This method can be used when the child restraint is
installed in the vehicle in rearward facing position. Small
adjustments may be possible with the child still in the
seat.
OR
B. Pull the top of the padded insert forward to expose the
"PUSH" label at the centre of the headrest. Place finger
on the "PUSH" button, press in towards restraint, lift the
headrest loop to adjust upward or downward.
Be sure to use the 'push' button label as a guide.
Press the 'push' button (approx. 10mm) into the recess
behind the cover. Once released check the headrest
has latched by attempting to lift the headrest using the
headrest loop.
IMPORTANT :
Ensure harness and headrest are positioned so that the shoulder straps are just above or inline
with the child's shoulders but not lower. The bottom of the headrest side wings will usually be
just above the infant's shoulders.
It is not necessary to remove the harness straps to adjust the headrest position. Refer to Care
and Maintenance for cover removal page 83.
72
Instructions for Installation & Use
OR
Headrest
loop
Push
button
PLACING CHILD IN THE RESTRAINT
A. Ensure the headrest and shoulder straps are
adjusted to the correct height for your child (see
page 71. Loosen shoulder straps by pressing the
harness adjuster and pull both shoulder straps
evenly. Pull out the desired amount of slack. Place
the two harness tongues into the Buckle Tongue
Holder (if supplied).
Move the harness buckle towards the harness
adjuster for easier fitment next time you put the
infant in the carrier.
B. Place child in the restraint and feed each arm
through the shoulder straps. Pull harness buckle up
between child's legs.
Pull
Press
Harness
Tongue
Holders
73
Instructions for Installation & Use