Britax Safe-n-Sound BS7300E-i20133 Series Instructions For Installation & Use page 17

F. Replace the centre panel flap, ensure the
harness buckle is through the panel. Connect to
the back panel of the cover. Replace the padded
insert (if supplied). Do not use padded insert if
the child's shoulders reach the lower shoulder
height marker or the child no longer fits the
insert. See page 45 for advice on positioning the
shoulder straps.
NOTE: Seatbelt extenders should not be used
if the seatbelt is not long enough to secure the
child restraint. If they are used then the buckle
must not enter the seating zone.
PADDED INSERT
The padded insert may be used until the child's shoulders
reach the lower shoulder height marker, or the padded
insert causes discomfort.
The padded insert's are not required for forward facing but
may be used to lift the child if their shoulders are below the
lower shoulder height marker.
32
Instructions for Installation & Use
Padded insert
G. If upper anchorage strap is folded up for storage
undo storage strap to lengthen. Fully press adjuster
button (1) while pulling upper anchorage strap (2) to
lengthen.
H. Fit the attachment clip to the car's anchor fitting as
shown right. Make sure to remove as many twists as
possible from the upper anchorage strap.
I. Tighten top tether strap by pulling adjustment strap to
remove slack, leave the strap slack on the side the
baby will be placed into the seat from. Any slack will
be removed once the baby has been harnessed into
the seat.
J. Remove the slack from the adjustable top tether strap
by pulling adjustment strap, With the baby in harness,
remove all slack in the top tether strap. Roll up excess
strap and store in the pocket provided on the cover.
Do not tighten the top tether strap such that the
restraint is lifted up. Remove slack only.
Always remove slack from top tether.
A loose top tether is dangerous.
CAUTION:
CHILDREN CAN BE INJURED OR RESTRAINTS AND TOP
TETHER STRAP DAMAGED BY UNSECURED CARGO IN A
COLLISION. SECURE OR REMOVE HAZARDOUS CARGO
BEFORE USING THIS CHILD RESTRAINT.
Fully press Adjuster Button (1) while
pulling Upper Anchorage Strap (2) to
lengthen.
1
2
Attachment Clip
Attach
Car's Anchor Fitting
Pull Adjustment Strap to remove slack
Roll up excess
strap and store
in the pocket
attached to the
cover.
33
Instructions for Installation & Use