Siemens Sinamics G110M Getting Started page 88

Troubleshooting
Table 5- 1
RDY
GREEN - On
GREEN - Flashing
slowly
RED - On
RED -Flashing slowly RED - flashing slowly Firmware updated is complete - power ON reset
RED - Flashing quick-
ly
RED - Flashing quick-
ly
RED - Flashing quick-
ly
Table 5- 2
Off
RED - Flashing slow-
ly
RED - Flashing quick-
ly
Table 5- 3
YELLOW - On
YELLOW - Flashing
slowly
YELLOW - Flashing
quickly
Table 5- 4
PROFINET LED
LNK - On
LNK - Off
88
Description of general status LEDS
LED
BF
-
-
ORANGE - flashing
slowly
-
RED - On
RED - flashing quick-
ly
Description of fieldbus communications LED
BF LED Description of function
Cyclic data exchange (or fieldbus not in use - p2030 = 0)
Bus fault - configuration fault
Bus fault:
- no data exchange
- baud rate search - cannot detect the correct baud rate
- no connection - the connection between the Inverter and PLC has been lost
Description of SAFE LED
SAFE LED Description of function
Safety function is enabled - but not active
Safety function is active - no safety function faults have occurred
The converter has detected a safety function fault and initiated a stop re-
sponse
Description of PROFINET communications LED
Description of function
Link is active
Link inactive with no data being transferred
Description of function
Ready for operation (no active fault)
Commissioning or reset of factory settings
Firmware update in progress
required
General fault condition
Fault occurred during firmware update
Incompatible firmware or incorrect memory card
Distributed converter for SIMOGEAR geared motors
Getting Started, 01/2016, FW V4.7.6, A5E36100338B AD