Siemens Sinamics G110M Getting Started page 33

3. Fitting the terminal housing to the motor
Distributed converter for SIMOGEAR geared motors
Getting Started, 01/2016, FW V4.7.6, A5E36100338B AD
1. Remove the existing motor terminal housing (the terminal
housing will become the motor terminal housing).
2. Align the terminal housing with the motor terminal housing.
3. Secure the terminal housing to the motor terminal housing.
Notes:
• Ensure that the terminal housing is fitted to the motor with
the Power Module heatsink over the non-drive end of the
motor.
• There are three different terminal housings, please ensure
you have the correct terminal housing configuration for the
motor to which it is to be fitted.
• All the required fixing bolts are supplied in the packaging
with the product.
• On the FS80/90 terminal housings there are two additional
fixing points which are the earthing points between the
terminal housing and the motor. These earthing points must
be used and therefore, the earthing cable does not need to
be fitted.
• The FS80/90 terminal housings cannot be fitted directly
over the terminal block of the motor - the terminal block of
the motor must be removed from the motor, then the
terminal housing is fitted to the motor and then the motor
terminal block is fitted back onto the motor.
• Exact dimensions and fixing points of the terminal housing:
Mechanical Installation (Page 24).
• The tightening torques for fitting the terminal housing to the
motor terminal box are contained in the Operating
Instructions for the motor:
LA/LE motors for mounting on SIMOGEAR
gearboxes
(http://support.automation.siemens.com/WW/view/en/60666
508).
• If the SINAMICS G110M is ordered as a complete system,
then all mechanical and electrical installation is completed
in the factory prior to delivery.
Installation
3.2 System Installation
33