Appendix A: Linking To A Development Pc - ICP DAS USA PDS-220F Series User Manual

Appendix A: Linking to a Development PC

CA0910
Step 1: Connect the download-cable, CA0910, between the PDS-220Fx module and COM
1 (or COM 2) of the development PC, as per the diagram above.
Step 2: Slide SW1 to the Init mode position, as shown in the diagram above.
Step 3: Unzip the "7188XW_yyyymmdd.zip" file on the PC. The file is located in the
CD:\Napdos\MiniOS7\utility folder.
Step 4: Apply power (+Vs, GND) to the PDS-220Fx module. +Vs can be anywhere from
+12 ~ +48 V.
Step 5: Execute 7188XW.EXE/C#, and change the Baud rate to 115200 bps and parity,
data and stop bits to N81. "/C#" is the COM port of the development PC.
Step 6: Press [Enter] twice on the development PC:
TXD
PDS-220 Series User Manual (V1.0, Jun.2010) ----- 63
Init Mode
Run Mode