Battery - Mahindra Quanto Ems Diagnostic Manual

DIAGNOSTIC MANUAL
QUANTO
P0562

BATTERY

The Electronic Control Unit continuosly monitors the battery voltage for its proper functioning.The
normal operating voltage for EMS ECU is 8- 16 V.
.
NORMAL OPERATION

Ignition ON

EMS ECU receives a supply voltage of 8-16V
DTC DETECTING CONDITIONS

Ignition ON

The supply voltage to EMS ECU is less than 8 V for few
seconds.
DTC REACTIONS

Engine Check lamp will be continuously ON

EMS ECU switches OFF
HEALING CONDITION

Ignition Off/On
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd.,
will amount to unauthorized use and shall be liable for penalty/prosecution© 2012 Mahindra & Mahindra Ltd.
EMS
BATTERY VOLTAGE LOW ERROR
DTC INFORMATION
MAN-00201
SEP 2012/Rev 1
PROBABLE CAUSES OF FAILURE

Faulty Battery

Faulty Charging System

Open/Short in EMS ECU
ignition power wire

Malfunctioning EMS ECU
`
42