Table of Contents
Advertisement
To reset D-Show system hardware components:
Put D-Show in Config mode.
1
Go to the Options page and click the Devices tab.
2
Right-click any of the following hardware components:
3
• Console sections
• Sidecar
• Stage Rack
Choose Reset.
4
Simulating a D-Show Configuration with the
Standalone Software
With the D-Show Standalone software, you can use the De-
vices page to simulate a D-Show system of any size, and utiliz-
ing either D-Show Profile or D-Show Main and Sidecar units,
for purposes of preparing shows. See "Simulating a D-Show
Configuration" on page 214.
Other D-Show Options
Busses
The Busses page lets you customize characteristics for the Aux,
Variable Group, Solo, and Main busses.
Busses tab of the Options page
Auxiliaries & Variable Groups
These options let you designate bus link status, pick off
source, and stereo pan behavior.
For more information, see Chapter 10, "Auxes and Vari-
able Groups."
Links When enabled, this option links the corresponding
mono Aux or Variable Group busses into bus pairs. Control
changes affect both mono Aux busses, and the Follows Chan-
nel Pan option becomes available.
52
D-Show Profile Guide
Pickoff These options let you designate the pre-fader pickoff
point feeding each Aux or Variable Group bus. Choices in-
clude pre-EQ, pre-mute, and pre-fader (post-mute).
Follows Channel Pan Each channel can be panned indepen-
dently within each linked Aux or Variable Group bus pair, or
configured to follow the channel pan by enabling the Follows
Channel Pan option.
To change the Aux bus or Variable Group bus configuration:
Put D-Show in Config mode.
1
Go to the Options page and click the Busses tab.
2
Click Edit.
3
Configure the following settings:
4
• To link two mono Aux busses or Variable Group busses
into a bus pair, select the Link option for the correspond-
ing pair.
• Specify the panning for channels routed to Aux or Vari-
able Group bus pairs by selecting or deselecting the Fol-
lows Channel Pan option.
• Click to select the pickoff point for each bus (Pre-EQ,
Pre-Mute, or Pre-Fader).
Click Apply to reconfigure the system.
5
– or –
Click Cancel to exit without changing system settings.
Solo and Monitor Operations
These settings customize Solo and Monitor bus mode and op-
eration.
See Chapter 14, "Solo and Monitor Busses."
Type Solo mode choices include PFL (Pre-Fader Listen), Stereo
AFL (After-Fader Listen), and Solo-In-Place.
Auxes/Var Groups Follow AFL Causes the controls for an Aux
Send or Variable Group Send to be automatically displayed on
the Input Channel encoders whenever the AFL switch is
pressed on the corresponding output bus.
Auto Cancel Soloing a channel strip automatically takes any
currently soloed channels out of solo.
Input Priority Makes soloed inputs temporarily replace soloed
output busses on the AFL/PFL bus.
Mix to Monitors Mirrors the functionality of the Mix to Moni-
tors switch on the control surface.
Level Trim Mirrors the functionality of the Solo/PFL level con-
trol on the control surface
Advertisement
Table of Contents
