Table of Contents
Advertisement
To link or unlink inputs to Matrix or PQ mixers:
Go to the Outputs page, and click to display the Matrix or
1
PQ mixer.
Click the checkboxes below any adjacent inputs to link or
2
unlink them. A check mark in the checkbox indicates a linked
input source; an empty checkbox indicates unlinked sources.
Selected PQ
output
Link controls in the PQ page
Relinking and Offsets
When inputs are relinked, their level and on/off state will
change as follows:
Level Each channel maintains any offset between the two
channels. This offset is not maintained if both linked controls
are adjusted beyond their maximum or minimum.
On/Off Each channel maintains its discrete on/off state at the
time the sources are relinked. For example, if one channel is
on and the other is off the stereo input will maintain these set-
tings after relinking, thus providing a stereo source with one
channel on, and the other off. Toggling one channel from Off
to On results in both channels switching On; toggling one of
the linked channels from On to Off results in both channels
switching Off.
Resetting Matrix Mixer and PQ Mixer Input
Controls
You can reset level, pan and stereo link settings for any matrix
or PQ mixer. Input source assignments persist.
To reset a Matrix mixer or PQ mixer parameter to its default
value:
PQ mixer
Select one or more Matrix or PQ mixers you want to change.
1
Right-click the encoder on-screen and choose Reset.
2
To reset all Matrix mixer or PQ mixer parameters to their default
values:
Select one or more Matrix or PQ mixers you want to change.
1
Click to link or unlink
Click the pop-up menu at the bottom of the mixer area and
2
choose Reset Mix.
Resetting a mix by right-clicking
Clearing Matrix Mixer and PQ Mixer Settings
You can clear mixer input assignments to quickly set all the
input sources to None.
To clear Matrix or PQ mixer input assignments:
Select one or more Matrix mixers or PQ mixers you want to
1
clear.
Click the pop-up menu at the bottom of the mixer area and
2
choose Clear Mix Sources.
Copying Matrix Mixer and PQ Mixer Input
Settings
You can copy mixer settings from one Matrix mixer or PQ
mixer to another mixer of the same type. This lets you quickly
duplicate monitor mixes or other signal feeds.
To copy settings between mixers:
Select the Matrix mixer or PQ mixer that you want to be the
1
destination of the copied settings so that it is displayed
on-screen.
Click the pop-up menu at the bottom of the mixer area,
2
choose Replace With Mix and Mix Sources From, then choose
the mixer whose settings you want to copy to the current
mixer.
Copying mixer settings overwrites all the settings on the
destination mixer.
Chapter 11: Matrix Mixers and PQ Mixers 97
Advertisement
Table of Contents
