DigiDesign D-Show Profile Manual page 166

Output Encoders
The Output encoders can be placed into Insert mode to adjust
any selected plug-in. Plug-in parameters map to the eight en-
coders and their switches; additional parameters are accessed
with the Previous Page and Next Page switches.
Output Encoders
Encoders and Insert mode switch in the Output section
To adjust a plug-in from the control surface:
Select the channel or bus on which the plug-in is inserted.
1
To select a bus processing plug-in, bank to and select the FX
Return or other channel assigned as the plug-in output.
In the Insert Processing section of the ACS, press the Select
2
switch for the plug-in so that its switch is lit.
Press the Insert Mode switch, located near the Output en-
3
coders. The first page of plug-in parameters is mapped to the
eight Output encoders.
To reset a parameter to its default value, hold the Alt key
4
while rotating or pushing an encoder.
To adjust with greater resolution, hold the Ctrl key while ro-
5
tating an encoder.
Press Previous Page or Next Page to bank to other plug-in pa-
6
rameters.
Some delay plug-ins include automatic beat clock and
tempo controls (such as the Tempo Sync feature in the
Digidesign Mod Delay plug-in). These types of plug-in con-
trols default to On, or active. Be sure to manually deacti-
vate Tempo Sync or the equivalent in these plug-ins.
156 D-Show Profile Guide
Display of Plug-Ins in Insert Mode
While in Insert Mode, the Output LCD displays the value and
name of the 8 currently banked plug-in parameters in the up-
per and lower row, respectively, for each parameter.
In this default Insert Mode view, adjusting an Output fader
temporarily shows fader level in the lower row of the Output
LCD for that channel, replacing the parameter name display.
Alternate Insert Mode View
Insert Mode
You can use an alternate view to have Insert Mode display pa-
switch
rameter values in the upper row and the associated bus name
in the lower row.
To view values and bus names for the Output encoders in Insert
Mode:
Press Alt (or Default)+Insert Mode.
■
Using the Source Switch
The Source switch toggles Input displays to show the names of
bus-fed plug-ins routed to a channel. Use the Source switch to
quickly identify which FX Returns or other channels are being
used as plug-in returns.
To view encoder values and bus names for Input or FX Return
channels:
Press the Source switch, to the left of the Input LCD.
■
Bypassing Plug-Ins
To bypass a plug-in:
Select the channel on which the plug-in is inserted.
1
In the Insert Processing section of the ACS, press the In/Out
2
switch for the plug-in to toggle between in-circuit/out-of-cir-
cuit. When the switch LED is lit, it indicates that the plug-in is
in-circuit. When unlit, the plug-in is out-of-circuit (bypassed).
Unassigned
LED indication of in circuit and out of circuit (bypassed) inserts
In
Out
In/Out