Table of Contents
Advertisement
Setting Input Gain
Gain can be controlled from individual channel strips or from
the ACS section.
Gain
Compressor
Threshold
HPF
Input control assignment switches for input channel encoders
Clip LED
+48 V
Input Polarity
Gain
Safe
Input controls in the ACS
To adjust input gain for a channel:
Do one of the following:
1
• In the Encoder Assignment section, press the Gain switch
to assign gain control to the rotary encoders.
– or –
• Target the channel by pressing its Select switch. Gain
control for the channel is assigned to the Gain rotary en-
coder in the ACS Input section.
Adjust the gain by turning the assigned rotary encoder.
2
To adjust input gain using the Gain Guess feature:
Press and hold the assigned rotary encoder while the chan-
1
nel is receiving input signal. The LED flashes to indicate level
sampling.
Release the rotary encoder to the current gain guess. Gain
2
will be set so the incoming signal reaches 0 dB peak (if Peak
mode is selected) or 0 dB RMS (if RMS mode is selected).
66
D-Show Profile Guide
Pan
Gate Threshold
Delay
Encoders (1–24)
Name display
20 dB Pad
Setting Right Offset on Stereo Channels
On stereo Input Channels and FX Returns, the Gain control
affects both the left and right channels. The Right Offset fea-
ture lets you offset the gain of the right channel relative to the
left channel by –20 dB to +20 dB, within the overall gain lim-
its.
To adjust channel gain offset for a stereo channel:
Go to the Inputs page and target the stereo channel.
1
Adjust the right channel gain using the on-screen Right Off-
2
set encoder. offset by turning the assigned rotary encoder.
Stereo Level Offset Indication
The Stereo LED below the channel meter flashes when the dif-
ference in signal level between the left and right channels is
12 dB or greater.
Pan
Pan adjusts channel pan (for mono Input Channels) and ste-
reo balance (for stereo Input Channels and FX Returns), allow-
ing you to control panning of signal to Groups or to Mains.
To adjust channel pan/balance:
In the Encoder Assignment section, press the Pan switch to
1
assign pan/balance control to the rotary encoders.
Adjust the channel pan/balance by turning the assigned ro-
2
tary encoder.
Width
Width adjusts the stereo image of stereo Input Channels and
FX Returns by controlling ganged pan positions of the left and
right channels, in opposite directions.
Width can be adjusted from full L–R, to mono, to full reversed
L–R. Width controls are not available on mono channels.
To adjust width of a stereo channel:
Go to the Inputs page and target the stereo channel.
1
Adjust width by turning the on-screen Width rotary en-
2
coder. Turning the encoder clockwise moves the width to full
stereo, and counter-clockwise moves the width to reverse ste-
reo. The center position represents mono.
Advertisement
Table of Contents
