Table of Contents
Advertisement
Graphic EQ Controls
The Input Faders provide control of Graphic EQ frequency
bands. You can also use on-screen controls to adjust graphic
EQ parameters.
Selected EQ bands
Graphic EQ controls on the control surface
To enable the graphic EQ:
Target an Output bus with a graphic EQ assigned. If no
1
graphic EQ is assigned, display the 31-Band Graphic Equalizer
tab in the Outputs page and assign one using the Graphic EQ
pop-up menu.
Click the In button on-screen to toggle in/out status. When
2
enabled, the In/Out switch LED lights.
To set a graphic EQ curve:
Press the Graphic EQ band switch or click on-screen to select
1
the appropriate bank of graphic EQ bands: (20 to 630 Hz,
800 Hz to 20 kHz). Inputs 1–16 are temporarily replaced with
frequency fader controls.
Adjust one of the 16 faders controlling the selected graphic
2
EQ bands.
Press another Graphic EQ band switch or click on-screen to
3
select another bank of graphic EQ bands and adjust as needed.
To adjust graphic EQ gain:
Use the on-screen Output control.
■
Resetting Graphic EQ Parameters
To reset a band to its default setting, do one of the following:
Hold the Default switch and press the Select switch on the
■
fader corresponding to the graphic EQ band.
Right-click the individual band fader on-screen and choose
■
Reset.
Alt-click the band on-screen.
■
To reset the entire graphic EQ to flat:
Right-click anywhere in the Graphic EQ section on-screen
■
(but not directly on a fader) and choose Reset GEQ Section.
140
D-Show Profile Guide
EQ band
selectors
Adjusting EQ Plug-Ins
D-Show compatible EQ plug-ins can map their gain, fre-
quency, and Q/bandwidth controls to corresponding encod-
ers on the control surface.
When a plug-in provides additional parameters beyond those
that map to the dedicated EQ encoders, you can use the Out-
put encoders in Insert Mode and the Previous/Next switches.
All plug-ins, including EQ plug-ins that do not map directly
to dedicated D-Show EQ encoders, can be controlled using
the Output encoders in Insert mode.
To adjust an EQ plug-in from the control surface:
Target the channel with the plug-in by pressing the channel
1
Select switch.
Press the plug-in Select switch in the ACS section.
2
Do one of the following:
3
• If the EQ plug-in maps correctly, adjust parameters by
pressing or turning the corresponding ACS EQ encoders.
– or –
• If the EQ plug-in does not map to the ACS controls, press
the Insert Mode switch in the Output section. Use the
Output encoders to adjust parameters, and use the Previ-
ous Page and Next Page switches to access other pages,
bands and parameters.
For more information, see Chapter 19, "Plug-Ins."
EQ Settings and Presets
Built-in parametric and graphic EQ settings can be copied and
pasted between channels. EQ presets can also be saved and
loaded to archive and transfer settings.
Copying and Pasting EQ Settings
To copy and paste an EQ setting:
Do one of the following:
1
• To copy a parametric EQ setting, right-click the on-screen
EQ section or EQ graph (not on an encoder) and choose
Copy EQ Settings.
– or –
• To copy a graphic EQ setting, right-click the graphic EQ
display (not on a fader) and choose Copy GEQ Settings.
EQ Reset/Copy/Paste pop-up menu
Advertisement
Table of Contents
