DigiDesign D-Show Profile Manual page 93

Working with Stereo Group Busses
When configured as stereo busses, Groups can operate in the
following modes:
Simple Mode
In Simple Mode, all 8 Group busses function only as true ste-
reo busses.
Expert Mode
In Expert Mode, any of the 8 stereo Group busses can be set to
act as true stereo or as dual mono busses, on a per channel ba-
sis.
To set the link status of individual stereo Group busses for a
channel (Expert Mode only):
Make sure Stereo Group Panning is set to Expert Mode.
1
Select an Input Channel or FX Return whose signal you
2
want to route to a Group bus. To select multiple channels, use
the Multi-Select switch next to the input faders.
In the ACS Bus Assigns section, press the Stereo Pan switch.
3
The switch flashes yellow to indicate bus link mode.
Press any of the Group switches (1–8) to set the correspond-
4
ing bus to stereo or dual mono. The Group switches flash yel-
low to indicate stereo, or flash green to indicate dual mono.
Press the flashing Stereo Pan switch to confirm the bus link
5
status for the selected channels.
To use dual mono Group busses (Expert Mode only):
Make sure the Group busses are configured as stereo busses.
1
See "Configuring Aux, Group, and Variable Group Busses" on
page 70.
Make sure the link status of the Group busses you want to
2
use is set to dual mono.
When routing channels to a dual mono Group bus, the Stereo
Pan switch will be off and the Group switch will light green to
indicate dual mono operation.
Chapter 9: Groups 83