Table of Contents
Advertisement
To reset system hardware:
Put D-Show in Config mode.
1
Go to the Options page and click the Devices tab.
2
Right-click any of the following hardware components:
3
• Inputs section
• ACS sections
• Outputs section
• Stage Rack
Choose Reset.
4
Resetting a unit in the Options > Devices page
Using the System Restore CD to
Update or Restore the System
One copy of the System Restore CD is included with each sys-
tem. The System Restore CD provides software installers to up-
date or restore a system.
Updating or Re-Installing Updating or re-installing D-Show
software lets you replace Digidesign software (including new
installers for factory-installed plug-ins) but preserve any saved
Shows and Presets. Use this option to update system software
or firmware, or to re-install system software or the installer for
a factory-installed plug-in.
All plug-Ins must be reinstalled after updating from the Sys-
tem Restore CD. Factory-installed plug-ins are immediately
available to be reinstalled, while other plug-ins from Digide-
sign and other manufacturers must be reinstalled from their
installer discs.
Full System Restore Performing a full system restore com-
pletely uninstalls D-Show before replacing it with new soft-
ware. All D-Show data folders and files are removed. Be sure to
transfer and archive needed data before performing a system
restore. All plug-ins must be re-installed after restoring the sys-
tem.
A System Restore CD and CDs of any plug-in installers
should be kept with the system at all times.
To start, update, or restore a system using the System
Restore CD:
Make sure outputs, speakers, and power amps are muted.
1
Insert the System Restore CD into the D-Show CD-ROM
2
drive on the FOH Rack.
Press the two Reset switches on the front of the FOH Rack si-
3
multaneously to restart the system, then press and hold F10
on the keyboard until either of the following occur, depend-
ing on your hardware:
• If the system begins to boot off the Restore CD, proceed
to step 4.
• If the Restore CD text screen appears, release F10 and use
the Up and Down Arrow keys to select the CD drive, then
press Enter. This launches using the software on the in-
serted System Restore CD. Continue to step 4.
Some models of USB keyboards require repeated pressing of
F10 (holding it down in between pressings) to register.
Do one of the following to update or restore D-Show soft-
4
ware:
• To update D-Show software while keeping any Show files
and Preset files on the system, press "u" (lower-case). In
the Update confirmation screen, press Shift+U (up-
per-case) to proceed. Follow the on-screen instructions to
begin installation.
– or –
• To fully restore the system (completely removing all files
on the system), press "r" (lower-case). (Or press P to re-
turn to the previous screen.) When the Restore confirma-
tion dialog appears, press Shift+R to proceed. Follow
on-screen instructions to complete the system restore op-
eration.
Select an option in the Ready to Resume dialog as appropri-
5
ate (see "Resuming Normal Operation" on page 230).
Follow any additional instructions on-screen for plug-ins or
6
authorizations.
Remove the D-Show System Restore CD from the FOH Rack
7
CD-ROM drive.
Re-install any plug-ins from their installer discs, as neces-
8
sary.
Before re-installing plug-ins after updating D-Show soft-
ware, make sure they are the current versions available. If
an updated versions of a plug-in is available, install it from
its installer CD-ROM.
Chapter 28: Troubleshooting 233
Advertisement
Table of Contents
