Tool Target - Setting; Set Target; Audit Mode; Set Angle Limit - norbar NorTronic Series Operator's Manual

TOOL TARGET - SETTING

Set Target

Set Target
N·m
0.0
Minimum =
•
0 (No

Audit Mode

NOTE: This screen will only be shown if Angle is Enabled
'Active from' threshold.
Audit mode?
✘
'✓'
• go to

Set Angle Limit,

Set Angle Limit
NOTE: This screen will only be shown if
Set Angle Limit
5°
• Minimum = 1, Maximum =

Set Angle Target

NOTE: This screen will only be shown if '
Set Angle
32°
• Minimum = 0, Maximum =
44
Press
Press
The
Target), Maximum =
100%
Press
Press
or
Set Angle.
The
'✘'
go to
Set
Press
Press
The
720.
Press
Press
The
999.
or to change.
to confirm and go to the
button is not functional.
of NorTronic torque capacity.
®
'
✓
or to enable
to confirm and go to either
button is not functional.
Angle.
was selected on the Audit mode? screen.
'✓'
or to change value.
to confirm and go to
button is not functional.

' was selected on the Audit mode? screen.
or to change.
to confirm and go to
button is not functional.
Audit mode?.
'
in Set up and Target is larger than
'✓' '✘'.
or disable
Set Angle Limit
Options Menu.
Set Torque Target.