Button Functions; Measure Display - norbar NorTronic Series Operator's Manual

BUTTON FUNCTIONS

Throughout set up and operation, the buttons perform the following functions:
Button

MEASURE DISPLAY

NOTE: Both of the displays on the NorTronic
11
13
# Function
1 Number of readings that have been saved for the current Target
2 Shows the next peak reading that will be saved to the NorTronic
3 Bluetooth
4 USB connected to P.C. (TDS)
5 Low Battery / Flat Battery
6 Target less than 10% of Tool Capacity (ISO6789:2017)
7 Current Torque Units
8 Torque reading
9 Angle reading
10 Current Snug Torque & Angle Target
11 Torque CRS has been changed from default value
12 Multiplier in use
13 Audit Target
36
Operation
Change Target
Zero Torque & Angle display if below
the
Active From
Cancel the peak reading if above the
threshold and send via
Active From
USB / Bluetooth
Exit the measure display
Save test results to NorTronic
12
M
19

1 2
3
connected
®
Function
threshold.
®
®
® show the same information at all times.
29°
T = 100 + 30°
332.1
I<10%
6
5
4
set up
Scroll through options or change a
selected value.
When a value,
changing
for a
down faster rate
Confirm a setting.
Exit current menu / screen.
None
10
N·m
7
(if Auto Reset enabled)
®
the
hold button
of change.
9
8