Setting Shut-Off Torque
The torque applied by the Pneutorque
The following values need to be entered:
Torque applied
'StOP' limit
4% tool capacity
0
NOTE:
The tool will not operate whilst setting the shut-off torque.
TIP:
When altering the limit settings press and hold or to increase speed of change.
®
depends on the shut-off setting.
Tool Display
unit
Hi
Lo
StOP
SEc
Fin
FIGURE 5 – Tool Display
Tool shuts off
FIGURE 6 – Typical Torque Application
Description
Torque units (lbf·ft / N·m)
High limit for torque
Low limit for torque
Shut-off torque
Reset time
Finish
Unit selected LED's (Red)
Response
time
X ON
'Hi' limit
ON
'Lo' limit
X ON
Time
Tool stops
11