Moffat turbofan E32SUBC Service Manual page 46

6
Service Procedures
5) Undo two nuts from outside cabinet, and two
screws inside cabinet securing float switch
bracket to proofer.
6) Remove float switch assembly from proofer.
NOTE: The float switch bracket has been
silicone sealed, so it may therefore
be necessary to cut around the
bracket with a sharp knife to assist
with removal. Clean off all remain-
ing silicone.
7) Remove the float switch sleeve, and undo the
nut securing the float switch to the bracket.
8) Remove the float switch from the bracket,
replace, and reassemble in reverse order.
NOTE: Ensure float switch bracket is RTV
silicone sealed to prevent steam
leakage.
Float switch sleeve
Float switch nut
Float switch
Figure 6.3.16b
E32SUBC OVEN and PROOFER
Revision 3
42
© Moffat Ltd, September 2009