Motor; Motor Timer; Motor Capacitor; Outer Glass - Moffat turbofan E32SUBC Service Manual

6
Service Procedures
6.2.9

Motor timer

1) Remove the right hand service panel (refer
6.1.2).
2) Remove the screws securing the motor timer
to the gear plate.
3) Fit the new timer to the gear plate, and
transfer the wires from the old timer.
Figure 6.2.9

6.2.10 Motor capacitor

1) Remove the right hand service panel (refer
6.1.2).
2) Undo the nut securing the capacitor to the
mounting bracket.
Motor capacitor
Figure 6.2.10
3) Remove the capacitor wires, noting their
positions.
4) Fit new capacitor
reverse order.
E32SUBC OVEN and PROOFER
Revision 3
Motor Cams ( Rotate
one revolution every
three minutes
and reassemble in

6.2.11 Outer Glass

1) Remove the
top pivot to the door whilst supporting the
door. The pivot can now be removed, and
the door removed from the oven..
2) Remove the bottom pivot (two screws), and
the door handle and roller catches (two
screws top and bottom).
Top
pivot
Bottom
Pivot
3) The stainless steel door outer can now be
removed.
4) To replace the outer glass, simply remove
and replace, taking care that the outer seals
are positioned correctly around the glass
edge.
Ensure when replacing that the side with the
'L' mark is inside the door (not on the front of
the oven). This ensures the correct operation
of the 'Low E' glass.
5) Reassemble in reverse order and refit door to
oven.
36
two screws securing
Door
Handle
Figure 6.2.11
© Moffat Ltd, September 2009
the