Inner Glass; Door Seals; Door Pivot Bushes - Moffat turbofan E32SUBC Service Manual

6.2.12 Inner Glass

1) Remove the outer glass (refer 6.2.11).
2) Uncrimp the retaining angles and remove
inner glass.
3) Replace with new glass.
Ensure when replacing that the side with the
'L' mark is inside the door (not inside the
oven). This
operation of the 'Low E' glass.
4) Reassemble and refit door to the oven.
Figure 6.2.12

6.2.13 Door Seals

1) Open oven door.
2) To remove, hold at their centre point and pull
forward until they unclip
3) Refit new seals.
NOTE: Fit top and bottom seals first, with
open side of seal facing downwards.
Fit side seals with open side facing
outwards.
Figure 6.2.13
E32SUBC OVEN and PROOFER
Revision 3
ensures the correct
Retaining
Angles
Door
Seals
Service Procedures

6.2.14 Door Pivot Bushes

1) Remove door
2) Remove the top and bottom pivot brackets
(two screws).
3) Door bushes can now be removed and
replaced.
4) Reinstall door by reversing steps one to two
of section 6.3.11.
37
Two
Screws
Figure 6.2.14
© Moffat Ltd, September 2009
6