Cleaning / Maintenance; Cleaning Oven; Cleaning Proofer - Moffat turbofan E32SUBC Service Manual

WARNING: ALWAYS TURN THE POWER SUPPLY OFF BEFORE CLEANING.
IMPORTANT: THIS UNIT IS NOT WATER PROOF.
DO NOT USE A WATER JET SPRAY TO CLEAN INTERIOR OR EXTERIOR OF THIS UNIT.
4.1

Cleaning Oven

Exterior
Clean with a good quality stainless steel cleaning
compound. Harsh abrasive cleaners may damage
the surface.
Interior
Ensure that the oven chamber is cool. Do not use
wire brushes, steel wool or other abrasive
materials. Clean the oven regularly with a good
quality oven cleaner. Take care not to damage
the fan or the tube at the left side of the fan
which controls the thermostat.
Oven racks
To remove, slide out to the stop position, raise
the front edge up, and lift out.
Lamp glass
To remove glasses, unscrew anti-clockwise. To
replace, screw in clockwise.
IMPORTANT: DO NOT OVER TIGHTEN LAMP
GLASS.
Door glass
Clean with conventional glass cleaners.
Oven seals
To remove, hold at their centre point and pull
forward until they unclip. Remove side seals first,
then top and bottom. The seals may be washed
in the sink, but take care not to cut or damage
them. To replace, ensure that the lip is facing
the oven opening. Fit the top and bottom seals
first, then the side seals.
E32SUBC OVEN and PROOFER
Revision 3

Cleaning / Maintenance

4.2

Cleaning Proofer

Cabinet
A good quality stainless steel cleaning compound
is recommended for cleaning the inside and
outside of the cabinet. Harsh abrasive cleaners
may damage the surface.
Side racks
To remove, take hold of the centre rung and lift
towards the proofer top.
horizontally, engage in holes and push down.
Door
Wash with warm water and detergent solution
using a soft sponge in straight lines up and down
the door.
Rinse with clean, warm water to remove
detergent. Dry off.
Clean door seal with warm water and detergent
solution using a soft sponge when required.
Water trough
Open right hand side rack and remove trough.
Clean with warm, soapy water. Rinse thoroughly
Water heating element
When the element becomes limed / scaled,
remove water trough and clean. Replace water
trough and half fill with white vinegar or acetic
acid then fill to the normal level with water.
Switch unit on.
approximately 30 minutes. Remove trough and
clean element with damp cloth when cooled.
Wash out trough and refit.
This procedure is recommended to be done once
a week. Frequency of cleaning the element may
be increased or decreased depending on the lime
depositing on the element.
19
To replace, hold
Turn on proofer and run for
© Moffat Ltd, September 2009
4