How To Change Production Settings; Advanced Menu - ATTACK DPX COMBI PELLET Series Instructions For Use Manual

9.6.3 HOW TO CHANGE PRODUCTION SETTINGS

To change the settings, select the required menu/parameters. By pressing the „+" button,
change the actual values. O: ...shows the actual temperature, N: ...can be changed to the new
value.
It is possible to increase the values by „+" and to decrease them by „−". By the „S" button is the
change confirmed and saved. If you do not wish to save the values, press the „ESC" button (Ex-
it/Escape).
Please, do not make any changes, until you have not read this manual.
Example:
EFFECT ADJ.
O: 1
Return to the production settings
To reset the production settings, select the advanced menu and enter the password (code num-
ber after „O"+5). Then, select the Menu/Setup and press the „S" button. This starts the reset of
the production settings.
Here you can also save your own settings, in the following way: by pressing the „+" button go to
„Save settings?" and save your settings by the „S" button. Exit menu by the „ESC" button.

9.7 ADVANCED MENU

The following data/parameters are adjustable by a qualified person only.
All the points of the advanced menu are available by pressing "S". The actual setting is perma-
nently displayed in the left bottom corner under „O:" (time/value), whereas the new value is dis-
played in the right bottom corner under „N": (time/value).
To increase and decrease time or values, press the buttons „+" and „−". To confirm and save the
new values, press „S". To exit without saving, press „ESC".
By enter into the advanced menu, add 5 to the displayed random number. Example: it can be
"18" on both for „O:" and „N:". Now press „+", until „N:18" is changed to „N:23", then press „S".
This enables access into the advanced menu.
For example:
MENU/ ADVANCED
O: 18
Old
Output setting:
EFFECT ADJ.
ENTER >
N: 2
N: 23
New
Here you can select from three outputs used like the „ACTUATOR
OUTPUTS" as ACTUATOR OUTPUTS in the generally accessible
EXIT
menu.
EN
52