Menu And Functions; Indications On Display - ATTACK DPX COMBI PELLET Series Instructions For Use Manual

EN

9.5 MENU AND FUNCTIONS

Functions of the burner are set via the menu buttons under the display. (see also options of set-
tings under the Production settings, below).
How to change settings of the pellet burner:
„S" – Menu/Enter: For activation of furtherrecords
and ENTER/SAVE of the changes.
„−": For comeback in menu and reduction of the ad-
justable values.
„+": For advance in menu and increasing of adjustable
values.
„ESC"– Exit/Escape: For exit from menu without sav-
ing the new values.
Values that can be set by the user are given in the following schedule:
MENU
EFFECT ADJ.
PELLET–TRIM
LOG
FINAL COMBUST.
MENU/ ADVANCED

9.5.1 INDICATIONS ON DISPLAY

Standby mode
PAUS.
OFF
Temperature sensor or thermostat starts.
Step 1: Test blow–through
TEST BLOWING
ON
Step 2: Fuel ration for heating up
IGNITION 1
ON
Step 3: Transition phase
TRANS. PHASE
ON
47
Explanation
Required output degree (1, 2 or 3)
Setting of the pellet ration supplied
Record of faults for control purposes
Instruction to burner for burn–out
Access into service menu via code
Nothing in the burner is started, burner waits for the signal from
thermostat to start.
FC: 0 %
The fan starts to operate and when the photocell recognizes the
value (%), the program continues.
FC: ? %
The fuel ration for heating up is supplied into the burner and pro-
gram waits for the „fire" signal from photocell.
FC: ? %
The transition phase begins, when the photocell and the control
??kW
system recognize the fire. Small, gradually increased amounts of
pellets are feeded into the burner, until the required pellet ration
FC: ? %
is achieved.