ATTACK DPX COMBI PELLET Series Instructions For Use Manual page 63

Burner turned off.
Check, which alarm is displayed.
If the display is black and without text, check the thermal fuse of the boiler. If there is no error,
probably is just the burner´s thermal fuse turned off. To start again, turn the power supply into
the burner off, remove the cover and press the small button between the connections of the
fuse of overheating. The thermal fuse is placed directly in the fuel–inlet tube. After restart,
mount the cover back and turn on the energy supply. Thermal fuse of the burner is switched off
at the temperature of 93 °C.
Signal text on display
ERROR: IGNITION FAILED
ERROR: FIRE LOST DURING COMBUSTION
ERROR: FIRE SENSOR
ERROR: CIRCUIT BOARD OVERHEATED
ERROR: TEMPERATURE SENSOR „TOO LOW"
ERROR: TEMPERATURE
HIGH"
ERROR: OPTO–SWITCH
ERROR: FAN ALWAYS ON
ERROR: FAN STOP
ERROR: FAN SLOW
ERROR: IGNITION 1
ERROR: STOCKER
ERROR: BURN–DOWN FAILED
ERROR: LIGHT LOST DURING BURNING
ERROR: SCRAPER NOT OPERATING
ERROR: SCRAPER JAMMED
Explanation
Faulty photocell, abnormal light
Temperature under the cover is
built–in operation thermostat
SENSOR „TOO
built–in operation thermostat
Ventilator rotates, when it is not
Ventilator is stopped, when it is
Pellet feeder is not connected to
Photocell recognizes signal also
15 minutes after setting „Burn–
Photocell does not recognize
Fault in circuit board of scraper
Extinction by heating, restart
failed
too high
Faulty thermal sensor of the
Faulty thermal sensor of the
Faulty circuit board
supposed to
not supposed to be
Ventilator rotates too slowly
First ignition trial failed
the burner
down"
fire, restart failed
or in grate gear
Grate moves too slowly
EN
Error code
at recording
10
11
12
13
14
15
16
18
19
20
21
22
23
24
25
26
62