Accessing Local Craft Procedures - Avaya 9608 Installing And Maintaining

The other provides access only to an administrable level of VPN capabilities and functions.
Using the VPN-specific option, the administrator can grant VPN users access to the VPN
procedure itself, while preventing these users from gaining access to any other Local
Administrative Procedure. The administrator may grant the VPN user permission to change VPN
settings or only to view the settings. For more information about access to VPN-only Local
Administrative Options, see the VPN Setup Guide for 9600 Series IP Telephones, 16-602968.
Caution:
Only trained installers or technicians should perform local administrative procedures. Perform
these procedures only if instructed to do so by the system or LAN administrator. Static
administration of these options causes upgrades to work differently with static administration
of these options than by dynamic administration. Values assigned to options in static
administration do not change with upgrade scripts. These values remain stored in the phone
until one of the following happens:
• You download a new boot file
• You reset the IP phone. See
Related links
Using local Administrative Menu procedures

Accessing local Craft procedures

Note:
In addition to the procedures listed here, the administrator may allow access to only the VPN
procedure, by setting the VPNCODE parameter in the settings file. For more information on
access to VPN-only Local Administrative Options, see VPN Setup Guide for 9600 Series IP
Telephones, 16-602968.
When you set PROCSTAT to 0, you have full access to local Craft procedures and you can invoke
local craft procedures during initialization or whenever the deskphone displays this message:
* to program
You can also initiate the Craft procedure at any other time the initialization process can support a
processing interrupt. If you set PROCSTAT to 1, the system allows access only to the VIEW craft
procedure for debugging purposes. You can invoke local Craft procedures only when the "* to
program" message displays during initialization.
Note:
The system supports the * to program message is supported even if the value of
PROCSTAT is 1, when the messages Address conflict, Subnet conflict, Bad
router? and Bad FileSv address display. You can gain execute the Craft procedures in
response to these messages as the situations requires corrective input.
March 2018 Installing and Maintaining Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP
Resetting system values
on page 36
Deskphones H.323
Comments on this document? infodev@avaya.com
Using local Administrative Menu procedures
on page 52.
37