Connections (Bottom Of Instrument) - Hach ORBISPHERE K1200 User Manual

3.3.4 Connections (bottom of instrument)

Cable protection shield
The cable protection located at the bottom of the instrument
and eventually removed, to get access to the bottom of the instrument.
Pull the plastic protection firmly towards you, then lower it as shown in
remove it completely, push it back against the wall. Proceed in reverse order to install the cable
protection. Make sure the 4 pins are securely in place.
Front panel door
A square key is provided to open the instrument front panel locks. The two locks are located on
the right side of the instrument on the top and bottom panels (number 9 in
The front panel can be easily pivoted to the left as shown in
instrument waterproof tightness, make sure the seal is clean and in good condition before
closing the front panel.
Figure 7 Cable protection shield in place
Figure 8 Cable protection shield lowered
1 - Power cable
2 - USB-B 4 pin connector (reserved for
manufacturing)
3 - Ethernet cable gland
4 - Sensor connection
5 - USB-A host connector for mass storage device
Note: The type of power cable connection will vary depending on the instrument specification.
(Figure 7 below) must be lowered,
Figure 8
Figure 8 below. To retain the
Figure 9 Wall/pipe mount connection panel
6 - External pressure sensor connection
7 - Input/Output 2 cable gland
8 - Input/Output 1 cable gland
9 - Keylock
Installation
below. To
Figure 9 below).
23