ECOTEST SPECTRA MKS-11GN Operating Manual page 35

2.3.3.6.2 Completing the identification process
After automatic or forced stop of the identification process the
following screen appears (Fig 10):
Figure 10 – Identification process completion
This screen shows the following data:
At the top of the screen, there is the ambient dose equivalent rate;
time in seconds since the start of identification, and pulse count rate
of gamma radiation. A field below will display radionuclides found,
or the message, saying "Nuclides not found" if radionuclides are not
detected.
In case radionuclides are detected, they appear in the
corresponding field in the format below:
NAME
• NAME – the name of the radionuclide (e.g., Co
• CATEGORY – the category to which the identified
radionuclide belongs ("NORM" - natural, "TECH" - industrial,
"MED" - medical, "SPEC" - special nuclear materials);
CATEGORY PEAKS RELIABILITY, where:
34
60
);