Gun Arm Mounts; Change Gun Position (Front And Back); Change Gun Position (Left And Right) - Graco LineLazer V 200MMA Operation - Repair - Parts

Gun Arm Mounts

This unit is equipped with front and rear gun arm mounts
to allow the operator to place the guns in the optimal
location.
Change Gun Position
(Front and Back)
1. Loosen gun arm knob and remove from gun arm
mounting slot.
2. Slide gun arm assembly (including gun and hoses)
out from gun arm mounting slot.
3. Slide gun arm assembly into desired gun arm
mounting slot.
ti27797a
3A6466A Operation, Repair, Parts
4. Tighten gun arm knob into gun arm mounting slot.
ti27798a
Make sure all hoses, cables, and wires are properly
routed through brackets and do NOT rub on tire.
Contact with tire will result in damaged hoses, cables,
and wires.
Change Gun Position
(Left and Right)
Removal
1. Loosen vertical gun arm knob on gun arm mounting
bar and remove.
ti27796a
2. Extend mounting bar on opposite side of the
machine.
Gun Placement
NOTICE
ti27799a
ti27800a
21