Graco LineLazer V 200MMA Operation - Repair - Parts page 41

Marker Layout Mode
The Marker Layout Mode feature sprays a dot or a
series of dots to mark an area.
1. Use to select Setup/Information. Press
to open Marker Layout Mode.
1
1
Ref. Description
Select a "Favorite", press for less than one sec-
ond.
1
Save a "Favorite", press and hold for more than
three seconds.
2 Exits and returns to Information Menu.
3 Select value to change.
4 Adjust spacing value.
2. Use arrow keys to set up a marker pattern.
3. Marker layout example shows a typical lane layout
for reflective markers. Set space sizes up to eight
consecutive measurements. By leaving zeros in any
space, Marker Layout Mode will skip to the next
measurement in a continuous loop.
Some other uses of Marker Layout Mode are:
• Multiple spaced handicap stall layout
• Double line stalls
8.00 ft.
3A6466A Operation, Repair, Parts
2
3
4
ti27860a
4.00 ft. 4.00 ft.
4. Set gun switch to skip line or solid line.
5. Press and release gun trigger control to start mark-
ing dots. Press and release gun trigger control again
to stop.
ti27912a
An indicator before and after Marker Mode on the
screen alternately flash when gun trigger control is
pressed to signal mode is active.
[1] 8.00´
[2] 4.00´
[3] 4.00´
[4] 16.00´
[5] 4.00´
[6] 4.00´
[7] 8.00´
[8] 0.00´
ti27862a
48.00 ft.
16.00 ft.
4.00 ft.
LineLazer V LiveLook Display
ti27918a
8.00 ft.
4.00 ft.
ti23812a
41