Gun Arm Mounts; Change Gun Position (Front And Back); Change Gun Position (Left And Right) - Graco LineLazer IV 250SPS Operation
Self-propelled line striper, for the application of line striping materials, for professional use only, for outdoor use only, not for use in hazardous locations or explosive atmospheres, maximum operating speed 10 mph 16 kph, maximum operating pressure: 3
Hide thumbs
Also See for LineLazer IV 250SPS:
- Manual (62 pages) ,
- Repair manual (54 pages) ,
- Installation and operation manual (33 pages)
Table of Contents
Advertisement
Gun Arm Mounts
This unit is equipped with front and rear gun arm
mounts.
Change Gun Position
(Front and Back)
1. Loosen gun arm knob and remove from gun arm
mounting slot.
2. Slide gun arm assembly (including gun and hoses)
out from gun arm mounting slot.
3A2090A Operation
ti18556a
ti18555a
ti18972a
ti18973a
3. Slide gun arm assembly into desired gun arm
mounting slot.
4. Tighten gun arm knob into gun arm mounting slot.
NOTICE
Make sure all hoses, cables, and wires are properly
routed through brackets and do NOT rub on tire.
Contact with tire will result in damaged hoses, cables,
and wires.
Change Gun Position
(Left and Right)
Removal
1. Loosen gun arm knob on gun arm mounting slot.
2. Remove guns from gun mounts (be sure to keep
track of which gun is 1 and which gun is 2).
Gun Placement
ti18980a
ti18974a
ti18975a
ti18981a
13
Advertisement
Table of Contents
