Flush Gun; Clean Outside Of Gun; Tip Guard Adapter; Clean Muffler - Graco LineLazer V 200MMA Operation - Repair - Parts

Maintenance

Flush Gun

If it is necessary to flush gun, use following procedure.
1. Follow Grounding Procedure (For Flammable
Flushing Fluids Only), page 12.
2. Flush with acetone into a grounded metal pail, hold-
ing a metal part of fluid manifold firmly to side of
pail. Use the lowest possible fluid pressure when
flushing.
3. Perform Pressure Relief Procedure, page 12.

Clean Outside of Gun

Wipe off outside of gun with acetone.
Spray Tip Adapter
Soak spray tip adapter in acetone. If necessary, clean
holes with 3/32" drill bit.
44

Clean Muffler

Remove and clean muffler with acetone.

Clean Fluid Manifold

Clean fluid manifold sealing faces with acetone and a
brush whenever removed from gun. Be sure to clean the
two fluid ports (X) in the top mating surface. Do not dam-
age the flat sealing surfaces. Coat with grease if left
exposed, to seal out moisture.
3A6466A Operation, Repair, Parts