Table of Contents
Advertisement
Positioning the Gun Arm Assembly
PUMP SIDE
1
402
First gun
Second gun
F
Fig. 15
The gun arms can be positioned for a variety of spraying
needs. The drawings on page 19 primarily show the guns
mounted on the pump side of the Linestriper. However,
one or both guns may be mounted on the engine side.
Whenever You Move the Guns
CAUTION
Do not kink the cables, which could prevent them
from properly triggering the guns.
Disengage the trigger cables and engage the gun trigger
safety latch first. See page 21. Do not kink the trigger
cables. Pull out more of the 50 ft. hose, if necessary.
After moving the guns, reposition the spray tip guard so
it is parallel to the ground and its "wings" face the front
and back of the unit. Disengage the gun trigger safety
latch and engage the trigger cable.
Vertical Position of the First or Second Gun
Loosen the arm clamp (6) and move the gun up or down.
Tighten the clamp. Engage the trigger cable.
NOTE: See Fig. 15. Collar (F) is located above and be-
low each gun. These collars can be adjusted to provide
stops for preset spray width positions for each gun.
B
4
405A
93
404
"WINGS" OF TIP GUARD
Horizontal Position of the First Gun
Method 1: Disengage the trigger cable. Loosen the car-
riage clamps (B,D) and slide the carriage bar (4) left or
right, so the gun will be outside the tire path. Tighten the
clamps. Engage the trigger cable.
Method 2: Disengage the trigger cable. Loosen the arm
clamp (6) and rotate the gun out to the side. Tighten the
bolt. Engage the trigger cable.
NOTE: Use methods 1 and 2 together to obtain the max-
imum distance of one gun from the unit, which is helpful
when spraying around obstacles.
Horizontal Position of the Second Gun
Method 1: Disengage the trigger cable. Loosen the
clamps (405A, 405B). Slide the second gun bar (404)
horizontally, being sure both clamps engage the second
gun bar. Tighten the clamps. Engage the trigger cable.
Method 2: Disengage the trigger cable. Loosen the arm
clamp (6) and rotate the gun out to the side. Tighten the
bolt. Engage the trigger cable.
NOTE: Use methods 1 and 2 together to obtain the max-
imum distance of 33–
of two guns.
ENGINE SIDE
D
405B
DETAIL A
E
B
A
0059
1
/
in. (851 mm) between the center
2
D
Advertisement
Table of Contents
