Agilent Technologies 7100 Technical Note page 9

6
Temperature control is enabled by default. The run only starts once the given temperature
NOTE
is reached. You can change this behavior by deselecting the box. A reboot (and
reconfiguration via the PreConfiguration Utility) is required.
7
8
9
Agilent 7100 CE in Empower Environment
Double-click CE G7150A on the right side of the window or select it and
click Configure at the bottom of the screen. The CE configuration
window opens.
Figure 6 Possible configuration options for CE
a Select the preferred Pressure Unit in the CE status dashboard for use
in the data and the pressure auxiliary channel
b If Temperature Control is not required, select Enable analysis with
temperature out of range.
c Enable Acquire for the Analog In Signal to collect data.
Click OK to close the screen.
Click OK to close the configuration editor.
Click OK to close the PreConfiguration Utility.
Set up and Configuration of CE in Empower 3
9