Agilent Technologies 7100 Technical Note page 14

Using the CE in Empower
It is not possible to see the detector signal while flushing the capillary. A feasible
NOTE
workaround is to check the numerical value of the detection wavelength, which is
displayed in the DAD part of the GUI (left side).
14
Following major actions are accessible via the CE Status dashboard
only (list does not claim to be exhaustive):
Change Cassette

Switch on lamp/Switch off lamp

Set Inlet Vial

Set Replenish Vial

Unload Replenish Lifter

Unload Inlet Lifter

Set Outlet Vial

Unload Outlet Lifter

Flushing Capillary by Flush

Injection by Apply Pressure

Apply Voltage

Replenish Vials

Change Bottles

Get Vial

All actions are performed immediately and the changes are reflected in
the graphical user interface (GUI). The system is in not ready state
(yellow), while performing these actions. After the action finishes, the
instrument resumes an idle state (green). Any direct change of a
parameter in the direct control menu (control and/or method) does not
change the current instrument method.
Agilent 7100 CE in Empower Environment