Set Up And Configuration Of Ce In Empower 3; Ce Instrument Set Up; The Ce Driver; Various Configuration Steps For Ce In Empower - Agilent Technologies 7100 Technical Note

Set up and Configuration of CE in Empower 3

CE Instrument set up

1
2
3
4

The CE Driver

The CE driver is part of the LC Driver and not listed as a separate
component. Therefore, Agilent ICF consists of two components; the Waters
integration adds one additional component. All three components must be
present in Control Panel > Programs and Features:
Figure 1

Various Configuration Steps for CE in Empower

To run CE in Empower the following items are required:


Creating a CE Project
Configure a specific CE project to review the acquired data later.
1
2
Agilent 7100 CE in Empower Environment
Close Empower.
Set up the CE system.
The CE uses LAN communication, e.g. via the multiport ethernet card.
Connect the CE to the LAC/E box. If another instrument is connected
to the LAC/E, connect via switch or hub.
Switch the instrument on.
Components in Programs and Feature
A CE specific project for data collection
The configuration of the CE instrument
Select File > New > Project to open the New Project Wizard.
Follow the instructions in the wizard screen and proceed with default
settings if no other values are given via Standard Operating Procedure
(SOP).
Set up and Configuration of CE in Empower 3
5