Sullair TS-32S Operator's Manual And Parts List page 55

Figure 7-8 Drive Coupling
Figure 7-9 Installation/Removal Bolts
Tighten the spacer mounting bolts and recheck off-
set and angular alignment (within the limits speci-
fied in Table 7-1 Installation
angular alignment is not within the specified toler-
ance, shim the front or rear of the motor separately
to correct. Recheck the vertical offset.
COUPLING ELEMENT INSTALLATION
Refer to Figure 7-9.
1. Insert installation/removal bolts provided through
clearance holes in spacer and into tapped holes
in adapters. A quantity of six (6) 5/16-18 UNC x
1 1/2" long bolts are required. Assemble all fas-
teners to a "finger tight" condition. Then tighten
each fastener in both flanges an additional 1 1/2
turns from the finger tight position. This will draw
the adapters toward the spacer and allow the
spacer assembly to clear the registers on the
adapter hubs.
2. Place compressed assembly into position. If
Data). If the vertical
Figure 7-10 Adapter Bolt Installation
MAINTENANCE
additional compression is required, tighten each
installation/removal bolt on each end an addi-
tional 1/2 turn.
3. Refer to Figure 7-10. Dip adapter bolt threads in
SAE 30 oil and insert bolts with lockwashers
through hub flange holes and engage tapped
holes in each adapter. REMOVE ALL INSTAL-
LATION/REMOVAL BOLTS FROM BOTH
FLANGES and put in a safe place for future use
should center section assembly require removal.
Tighten adapter bolts to the recommended
torque as given in Table 7-1 Installation
DISCPACK REPLACEMENT
Should discpacks require replacement, it is recom-
mended that new drive bolts, overload washers and
locknuts also be obtained. Order replacement kit
no. 02250044-346.
1. Remove old discpacks from adapters and spac-
er, and discard.
2. Install overload washers onto half of the new
Section 7
Data.
49