Working Frequency Settings - XIEGU X5105 Operation Manual

Working frequency settings

There are two methods for setting
working frequency of X5105, i.e., set by
using the large knob or multi-function
hand microphone.
Operation methods:
1. Set frequency by using large knob
Press [<] and [>] to move frequency

position cursor to left or right, so as
to select the frequency position of
expected step;
Rotate frequency knob and set the

frequency of current step.
2. Set frequency by using multi-function hand microphone
Press [F-INP ENT] key on hand microphone, and the X5105 will be in frequency setting state, and cursor will be flickering at the first place on the

left of frequency display position;
 Respectively input expected frequency values, and press [F-INP ENT] key again to complete frequency settings.
For example, press keys in following sequence to set current frequency as 51.050000MHz:
1.
Press [F-INP ENT] firstly;
5
2.
Respectively press
3.
Press [F-INP ENT] again to complete the settings.
Operation
PRE
MODE
ATT
NB RIT
MENU
1 . 0 5 0 0 0 0 number keys;
X5105
T/R DATA LINK
<
ATU
LOCK
V/M
Step selection key
A/B
Po
Large knob
41